CFTC jaw crusher pe 600 x 900 Two processing methods

At present, the sales volume of jaw crusher produced by CFTC is very considerable at home and abroad.

Two processing methods of CFTC jaw crusher pe 600 x 900:
According to the regional environment, there are two main processing methods in its work & mdash; & mdash; dry crushing and wet crushing. The difference between the two methods is mainly due to the water content of the material. Here are two ways:

1. Dry crushing: if the moisture content of the materials crushed by the jaw crusher is less than 4%, they will be crushed into dry crushing. The following features shall be noted:

(1) when crushing, it is necessary to set dust remover equipment to avoid dust flying and reach the production of environmental protection and energy saving

(2) the materials and commodities disposed of are boring

(3) when the material is finely ground, the power of the grinding powder is constantly floating according to the hardness of the material

(4) when the fine particles of the products are discharged from the pulverizer, they enter the cyclone powder collector of the products along with the air flow and are discharged through the powder outlet pipe

(5) when the moisture content of the material exceeds a certain amount, the particles adhere and the damage power decreases

2. Wet failure: the water content of the damaged material exceeds 50%, and the failure with liquidity is called wet failure, which is characterized by:

(1) reduce the occurrence of dust on the operation site, and increase the dust removal equipment according to the environmental pollution degree.

(2) the particle classification is relatively simple.

(3) the material has high water content and low grinding output value, which simply forms the phenomenon of material caking and blocking.

The above two kinds of damage methods have advantages and disadvantages in the production and application process of the jaw crusher, but the commonly used one is dry grinding. The wet grinding has large water content or excessive water content, which can only form low commodity, and even cause the crusher equipment fault. Therefore, dry crushing is often used for grinding various ore materials.

CFTC provide a complete set of equipment including crushing, screening, beneficiation, etc. The products have been exported to market of Southeast Asia, Middle East, Africa and the Americas. if you want to more about the :CFTC jaw crusher pe 600 x 900 Two processing methods,please leave message to us,we will contact you in 24 hours. jacker@cfcmining.com